The aluminum dirt trap as a substructure for 22 mm high mats and 25 mm high gratings. For indoor and outdoor use. Precisely made to measure in width and length. Optional: with water drain at no extra charge. Made to measure: If both dimensions (length and width) exceed 150 cm, the tub is made of several parts. Please contact us for information on your dimensions.
Aluminum dirt trap for entrance mats and gratings
For less maintenance under aluminum profile mats and the possibility of water drainage, you can install the aluminum dirt trap as a substructure under aluminum profile mats. The aluminum dirt trap is made to your exact measurements and can be used inside as well as outside of buildings.
As an option, you can install a water drain with the aluminum dirt trap. With the aluminum dirt trap you can choose at which position a water drain is installed. From the water drain, in turn, pipes must be planned for connection to the sewer system.
You can design large areas with the aluminum dirt trap. We can produce the aluminum dirt trap in almost all dimensions.
The aluminum dirt trap has an installation height of 80 mm and square tubes (30x30x3 mm) are inserted at regular intervals of approx. 30 cm in the running direction for the purpose of secure support of the aluminum profile mats.
Installation of the aluminum dirt trap for entrance mats and gratings
Normally, you will receive the aluminum dirt trap directly assembled.
Place the assembled aluminum dirt trap in the recessed screed or floor covering. Make sure that the upper edge of the frame is flush with the floor covering. The bed on which the dirt trap rests should have been prepared beforehand and must be absolutely flat and even so that the aluminum dirt trap rests properly.
Special features of the aluminum dirt collector:
- For best water drainage, the square tubes are mounted on feet above the bottom of the tray.
- Water drainage devices with strainer can be mounted anywhere.
-Large areas are covered with several tubs.
- There are no limits to individual design possibilities with these tubs.
Technical data of the ACCESSORIES aluminum dirt trap:
Aluminum profile: Torsion-resistant aluminum profile.
Installation height
80 mm
Corners:
Are mitered to fit exactly. The corners are connected with corner connectors and screws.
Bottom:
The floor is made entirely of aluminum plate.
Supplied with support bars that are recessed into the tub approximately every 30 cm.
Other available tubs tub is also available in stainless steel
Dimensions:
Recesses, curves and slopes according to sketches, drawings or templates are possible
Larger areas are composed of several tubs.
Utilization: Suitable for all types of walking traffic
Gewicht netto: 12500 g