ACCESSORIES aluminum angle installation frame for entrance mats

Aluminum angle frame for entrance mats

You will receive the individual angle profiles for the aluminum angle frame for entrance mats in 10,12,13,17,22,27 and 42 mm mat height mitered delivered. The individual angle profiles are connected at the corners with corner connectors and screws which are supplied with the angle profiles.

Then place the assembled frame into the recessed screed or floor covering. Make sure that the upper edge of the frame is flush with the floor covering. You can now fill the mat bed with leveling compound or similar material and thus also fix the aluminum angle frame in the floor.

It is important to create an even mat bed so that the aluminum profile mat lies flat in the mat bed afterwards.

For all picobello entrance mats in 10,12,13,17,22,27 and 42 mm mat height we recommend our aluminum angle frame to professionally frame the entrance mats.

Often for 10 mm thick entrance mats to frame Schlüter tile rails are a good alternative. However, you can also use our aluminum angle frame for 10 mm thick entrance mats.

Technical data of the ACCESSORIES aluminum angle mounting frame for entrance mats

Aluminum profile: Torsion-resistant aluminum profile
Dimensions of the aluminum profile:    
WRA12:15/24/3 mm  

WRA17: 22/24/3 mm

WRA22: 26/24/3 mm 

WRA27: 30/24/3 mm  

WRA42: 45/30/3 mm

Corners:    
Are mitered for a perfect fit

Connection:    
Corner connectors and screws are supplied for the corners. Final assembly to be done on site.

Other available frames:    
Frames are available for 10,12,13,17,22,27 and 42 mm high mats.

Dimensions:    
Custom made; from about 300 cm length, the aluminum profiles are supplied split. Connectors and screws are then supplied for the division.

Recesses, curves and bevels according to sketches, drawings or templates are possible.

Utilization: Suitable for all running traffic

Gewicht netto: 130 g