ACCESSORIES aluminum mounting frame for entrance mats
Configure your mat
Item number ERA12
The mounting frame made of aluminum to frame 10,12,13,17,22 and 27 mm high mats. For indoor and outdoor use. Exact fit made to measure in width and length. System for the floor layer or tiler with low construction height to put the frame on the screed. Easy installation: connect corners with corner connectors, insert the frame into the mat bed and fix it with leveling compound or similar.
Aluminum installation frame for entrance mats
You will receive the individual aluminum profiles for the installation frame for entrance mats in 10, 12, 13, 17, 22 and 27 mm mat height miter cut delivered. The individual aluminum profiles are connected at the corners with corner connectors and screws which are supplied with the aluminum profiles.
Then place the assembled frame into the recessed screed or floor covering. Make sure that the upper edge of the frame is flush with the floor covering. You can now fill the mat bed with levelling compound or similar material and thus also fix the installation frame in the floor.
It is important to create an even mat bed so that the aluminum profile mat lies flat in the mat bed afterwards.
For all picobello entrance mats in 12, 17, 22 and 27 mm mat height we recommend our installation frame to professionally frame the entrance mats.
Often for 10 mm thick entrance mats to frame Schlüter tile rails are a good alternative. However, you can also use our installation frame entrance mats.
Technical data of the ACCESSORIES aluminum mounting frame for entrance mats
Aluminum profile: Torsion-resistant aluminum profile
Dimensions of the aluminum profile:
ERA12: 13.5 mm H / 4.6 mm visible surface / 12.5 mm to mat support
ERA17: 17 mm H / 4.6 mm visible surface / 16 mm to mat support
ERA22: 20 mm H / 4.6 mm visible surface / 19 mm to mat support
ERA27: 25 mm H / 4.6 mm visible surface / 24 mm to mat support
Corners:
Are mitered to fit exactly
Connection:
Corner connectors and screws are supplied for the corners. Final assembly to be done on site.
Other available frames: Frames are available for 10,12,17,22,27 mm high mats.
Dimensions:
Custom made; from about 300 cm length, the aluminum profiles are supplied split. Connectors and screws are then supplied for the division.
Recesses, curves and bevels according to sketches, drawings or templates are possible.
Utilization: Suitable for all running traffic
Gewicht netto: 130 g