ACCESSORIES Stainless steel installation frame for entrance mats
Configure your mat
Item number WRE12
The stainless steel mounting frame to frame 12,17,22 and 27 mm high mats. For indoor and outdoor use. Precisely made to measure in width and length. Simple system: connect corners with corner connectors, insert frame into the mat bed and fix with leveling compound or similar.
Stainless steel installation frame for entrance mats
You will receive the individual angle profiles for the stainless steel installation frame mitered to fit exactly. The individual angle profiles are connected at the corners with corner connectors and screws which are supplied with the angle profiles.
Then place the assembled frame into the recessed screed or floor covering. Make sure that the upper edge of the frame is flush with the floor covering. You can now fill the mat bed with leveling compound or similar material and thus also fix the stainless steel angle frame in the floor.
It is important to create an even mat bed so that the aluminum profile mat lies flat in the mat bed afterwards.
For all entrance mats in 17, 22 and 27 mm mat height we recommend our stainless steel angle frame to professionally frame the entrance mats.
Technical data of the ACCESSORIES stainless steel installation frame for entrance mats:
Dimensions of the angle profiles:
WRE12:15/15/3 mm
WRE17: 20/20/3 mm
WRE22: 25/25/3 mm
WRE27: 30/30/3 mm
Corners:
Will be mitered to fit exactly
Connection:
Corner connectors and screws are supplied for the corners. Final assembly to be done on site.
Other available frames:
Aluminum frames are available
Dimensions:
Custom made; stainless steel profiles are supplied split for lengths of approximately 300 cm and above. Connectors and screws are then supplied for the division.
Recesses, curves and bevels according to sketches, drawings or templates are possible.
Utilization:Suitable for all running traffic
Gewicht netto: 7000 g